Junos OS Interfaces Command Reference - Juniper Networks

Junos OS 12.1 Interfaces Command Reference
136
Table 24: Ethernet Interface Operational Mode Commands (continued)
Task
Clear connectivity-fault-management policer statistics.
Clear all statistics maintained by CFM. (Routers that
support IEEE 802.1ag OAM CFM)
In addition, for interfaces that support ITU-T Y.1731
Ethernet frame delay measurement (ETH-DM), also clear
any ETH-DM statistics and frame counts for CFM
maintenance association end points (MEPs).
Clear Operation, Administration, and Management (OAM)
link fault management state information and restart the
link discovery process on Ethernet interfaces.
Clear Operation, Administration, and Management (OAM)
statistics link fault management statistics for Ethernet
interfaces.
Clear the statistics for all Ethernet ring protection groups
or a specific Ethernet ring protection group.
Check the reachability of a remote IEEE 802.1ag OAM
maintenance association end point (MEP) or maintenance
association intermediate point (MIP).
Manually rebalance the subscribers on an aggregated
Ethernet bundle with targeted distribution enabled.
Manually revert egress traffic from the designated backup
link to the designated primary link of an aggregated
Ethernet interface for which link protection is enabled, or
manually switch egress traffic from the primary link to the
backup link.
Force LACP link switchover.
Clear the lockout, force switch, manual switch, exercise,
and wait-to-restore states.
Test if APS is operating correctly.
Force traffic to switch from the active path to the alternate
path.
Lock the protection path, forcing the use of the working
path.
Command
clear oam ethernet
connectivity-fault-management
policer
clear oam ethernet
connectivity-fault-management
statistics
clear oam ethernet
link-fault-management state
clear oam ethernet
link-fault-management statistics
clear protection-group ethernet-ring
statistics
ping ethernet
request interface rebalance
(Aggregated Ethernet for Subscriber
Management)
request interface (revert | switchover)
(Aggregated Ethernet Link Protection)
request lacp link-switchover
request protection-group
ethernet-aps clear
request protection-group
ethernet-aps exercise
request protection-group
ethernet-aps force-switch
request protection-group
ethernet-aps lockout
Copyright © 2012, Juniper Networks, Inc.