Junos OS Interfaces Command Reference - Juniper Networks

Junos OS 12.1 Interfaces Command Reference
Table 50: show oam ethernet connectivity-fault-management mep-database Output
Fields (continued)
Field Name
MAC address
Auto-discovery
Priority
Interface name
Interface status
Link status
Remote MEP not
receiving CCM
Erroneous CCM received
Cross-connect CCM
received
RDI sent by some MEP
CCMs sent
CCMs received out of
sequence
LBMs sent
Valid in-order LBRs
received
1DMs sent
Valid 1DMs received
Invalid 1DMs received
320
Field Description
MAC address configured for the MEP.
Whether automatic discovery is enabled or disabled.
Priority used for CCMs and linktrace messages transmitted by the MEP.
Interface identifier.
Local interface status.
Local link status.
Whether the remote MEP is not receiving CCMs.
Whether erroneous CCMs have been received.
Whether cross-connect CCMs have been received.
Whether the remote defect indication (RDI) bit is set in messages that have been received. The
absence of the RDI bit in a CCM indicates that the transmitting MEP is receiving CCMs from all
configured MEPs.
Number of CCMs transmitted.
Number of CCMs received out of sequence.
Number of loopback messages (LBMs) sent.
Number of loopback response messages (LBRs) received that were valid messages and in sequence.
If the MEP is an initiator for a one-way ETH-DM session: Number of one-way delay measurement
(1DM) PDU frames sent to the peer MEP in this session.
For all other cases, this field displays 0.
If the MEP is a receiver for a one-way ETH-DM session: Number of valid 1DM frames received.
For all other cases, this field displays 0.
If the MEP is a receiver for a one-way ETH-DM session: Number of invalid 1DM frames received.
For all other cases, this field displays 0.
Copyright © 2012, Juniper Networks, Inc.