Junos OS Interfaces Command Reference - Juniper Networks

Junos OS 12.1 Interfaces Command Reference
show interfaces extensive
Syntax show interfaces extensive
Release Information Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 12.1 for PTX Series Packet Transport Switches.
Description Display extensive information about all interfaces configured on the router.
Required Privilege
NOTE:
• At some times, the cumulative byte counters displayed with the show
interfaces extensive command on the 10-Gigabit Ethernet MPC with SFP+
is not always increasing and cumulative and does not give the correct
results. There is a time lag in collecting these statistics, during which the
display might decrease or go from a nonzero number to zero. Eventually,
the counter will display the correct result.
• When the show interfaces extensive command is executed on a router with
an MPC or a T4000 Type 5 FPC, the Input packet rejects counter of the
Filter statistics field also displays statistics related to the following packet
errors:
• Invalid VLAN range
• Tagged packet received on an untagged interface
• When the show interfaces extensive command is executed on an interface
that is configured on T4000 Type 5 FPC, the IPv6 transit statistics field
displays:
• Total statistics (sum of transit and local statistics) at the physical
interface level
Options This command has no options.
Level
view
• Transit statistics at the logical interface level
List of Sample Output show interfaces extensive (Circuit Emulation) on page 39
38
show interfaces extensive (Fast Ethernet) on page 39
show interfaces extensive (Gigabit Ethernet) on page 41
show interfaces extensive (10-Gigabit Ethernet) on page 42
show interfaces extensive (IQ2 and IQ2E) on page 44
show interfaces extensive (100-Gigabit Ethernet) on page 47
show interfaces extensive (PTX5000 Packet Transport Switch) on page 49
Copyright © 2012, Juniper Networks, Inc.