14.12.2012 Views

Junos OS Interfaces Command Reference - Juniper Networks

Junos OS Interfaces Command Reference - Juniper Networks

Junos OS Interfaces Command Reference - Juniper Networks

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>Junos</strong> <strong>OS</strong> 12.1 <strong>Interfaces</strong> <strong>Command</strong> <strong>Reference</strong><br />

Table 73: T1 or E1 show interfaces Output Fields (continued)<br />

Field Name<br />

Flags<br />

Addresses, Flags<br />

Destination<br />

Local<br />

Broadcast<br />

Generation<br />

DLCI<br />

DLCI statistics<br />

Sample Output<br />

404<br />

show interfaces (T1,<br />

IMA Link)<br />

Field Description<br />

Information about the protocol family flags. Possible values are described in<br />

the “Family Flags” section under “Common Output Fields Description” on<br />

page 125.<br />

Information about the address flags. Possible values are described in the<br />

“Addresses Flags” section under “Common Output Fields Description” on<br />

page 125.<br />

IP address of the remote side of the connection.<br />

IP address of the logical interface.<br />

Broadcast address.<br />

Unique number for use by <strong>Juniper</strong> <strong>Networks</strong> technical support only.<br />

(Frame Relay) DLCI number of the logical interface. The following DLCI<br />

information is displayed: Flags, Total down time, Last down, and Traffic statistics<br />

or (Input packets, Output packets). Flags can be one or more of the following:<br />

• Active—Set when the link is active and the DTE and DCE are exchanging<br />

information.<br />

• Down—Set when the link is active, but no information is received from the<br />

DCE.<br />

• DCE-Unconfigured—Set when the corresponding DLCI in the DCE is not<br />

configured.<br />

• Configured—Set when the corresponding DLCI in the DCE is configured.<br />

• DCE-configured—Displayed when the command is issued from the DTE.<br />

(Frame Relay) Data-link connection identifier (DLCI) statistics.<br />

• Active DLCI—Number of active DLCIs.<br />

• Inactive DLCI—Number of inactive DLCIs.<br />

user@host> show interfaces t1-1/0/0<br />

IMA Link alarms : None<br />

IMA Link defects : LIF, LODS<br />

IMA Link state:<br />

Line : Not synchronized<br />

Near end : Rx: Unusable, Tx: Usable<br />

Far end : Rx: Unusable, Tx: Usable<br />

IMA link media: Seconds Count State<br />

LIF 0 OK<br />

LODS 0 OK<br />

Err-ICP 0 OK<br />

IV 0 OK<br />

Rx-FC 0 OK<br />

Tx-FC 0 OK<br />

FE-Defects 0<br />

Level of Output<br />

detail extensive none<br />

detail extensive none<br />

detail extensive none<br />

detail extensive none<br />

detail extensive none<br />

detail extensive none<br />

detail extensive none<br />

detail extensive none<br />

Copyright © 2012, <strong>Juniper</strong> <strong>Networks</strong>, Inc.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!