Junos OS Interfaces Command Reference - Juniper Networks

Table 31: show interfaces Gigabit Ethernet Output Fields (continued)
Field Name
OTN OTU
Received DAPI
Received SAPI
Transmitted DAPI
Transmitted SAPI
PCS statistics
Field Description
OTN OTU defects detected on the interface
• AIS—OTN AIS alarm.
Copyright © 2012, Juniper Networks, Inc.
• BDI—OTN OTU BDI alarm.
• IAE—OTN OTU IAE alarm.
• TTIM—OTN OTU TTIM alarm.
• SF—OTN ODU bit error rate fault alarm.
• SD—OTN ODU bit error rate defect alarm.
• TCA-ES—OTN ODU ES threshold alarm.
• TCA-SES—OTN ODU SES threshold alarm.
• TCA-UAS—OTN ODU UAS threshold alarm.
• TCA-BBE—OTN ODU BBE threshold alarm.
• BIP—OTN ODU BIP threshold alarm.
• BBE—OTN OTU BBE threshold alarm.
• ES—OTN OTU ES threshold alarm.
• SES—OTN OTU SES threshold alarm.
• UAS—OTN OTU UAS threshold alarm.
Destination Access Port Interface (DAPI) from which the packets were received.
Source Access Port Interface (SAPI) from which the packets were received.
Destination Access Port Interface (DAPI) to which the packets were transmitted.
Source Access Port Interface (SAPI) to which the packets were transmitted.
Chapter 4: Ethernet Interface Operational Mode Commands
(10-Gigabit Ethernet interfaces) Displays Physical Coding Sublayer (PCS) fault
conditions from the WAN PHY or the LAN PHY device.
• Bit errors—High bit error rate. Indicates the number of bit errors when the PCS
receiver is operating in normal mode.
• Errored blocks—Loss of block lock. The number of errored blocks when PCS
receiver is operating in normal mode.
Level of Output
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
219