Junos OS Interfaces Command Reference - Juniper Networks

Junos OS 12.1 Interfaces Command Reference
Table 101: ATM show interfaces Output Fields (continued)
Field Name
SDH PHY
SDH regenerator
section
SDH multiplex
section
580
Field Description
Active alarms and defects, plus counts of specific SDH errors with detailed
information.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
Subfields are:
• PLL Lock—Phase-locked loop
• PHY Light—Loss of optical signal
Active alarms and defects, plus counts of specific SDH errors with detailed
information.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
Subfields are:
• RS-BIP8—24-bit BIP for multiplex section overhead (B2 bytes)
• OOF—Out of frame
• LOS—Loss of signal
• LOF—Loss of frame
• RS-ES—Errored seconds (near-end regenerator section)
• RS-SES—Severely errored seconds (near-end regenerator section)
• RS-SEFS—Severely errored framing seconds (regenerator section)
Active alarms and defects, plus counts of specific SDH errors with detailed
information.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
Subfields are:
• MS-BIP24—8-bit BIP for high-order path overhead (B3 byte)
• MS-FEBE—Far-end block error (multiplex section)
• MS-FERF—Far-end remote fail (multiplex section)
• MS-AIS—alarm indication signal (multiplex section)
• BERR-SF—Bit error rate fault (signal failure)
• BERR-SD—Bit error rate defect (signal degradation)
• MS-ES—Errored seconds (near-end multiplex section)
• MS-SES—Severely errored seconds (near-end multiplex section)
• MS-UAS—Unavailable seconds (near-end multiplex section)
• MS-ES-FE—Errored seconds (far-end multiplex section)
• MS-SES-FE—Severely errored seconds (far-end multiplex section)
• MS-UAS-FE—Unavailable seconds (far-end multiplex section)
Level of Output
extensive
extensive
extensive
Copyright © 2012, Juniper Networks, Inc.