Junos OS Interfaces Command Reference - Juniper Networks

Table 132: Channelized T1 IQ and T3 IQ show interfaces Output Fields (continued)
Field Name
T1 media
Line encoding
Buildout
HDLC configuration
Field Description
Counts of T1 media-specific errors.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
The T1 media-specific error types can be:
• AIS—Alarm indication signal
• BEE—Bit error event
• BES—Bit error seconds
• BPV—Bipolar violation
• CS—Carrier state
• ES—Errored seconds
• EXZ—Excessive zeros
• FEBE—Far-end block error
• LCV—Line code violation
• LES—Line error seconds
• LOF—Loss of frame
• LOS—Loss of signal
• PCV—Pulse code violation
• SEF—Severely errored framing
• SEFS—Severely errored framing seconds (section)
• SES—Severely errored seconds
• UAS—Unavailable seconds
• YELLOW—Errors at the remote site receiver
Line encoding used: B8ZS or AMI.
Buildout setting.
Copyright © 2012, Juniper Networks, Inc.
Information about the HDLC configuration.
• Policing bucket—Configured state of the receiving policer.
• Shaping bucket—Configured state of the transmitting shaper.
• Giant threshold—Giant threshold programmed into the hardware.
• Runt threshold—Runt threshold programmed into the hardware.
• Timeslots—Configured time slots for the interface.
• Line encoding—Line encoding used: B8ZS or AMI.
• Byte encoding—Byte encoding used: Nx64K or Nx56K.
• Data inversion—HDLC data inversion setting: Enabled or Disabled.
• Idle cycle Flag—Idle cycle flags.
• Start end Flag—Start and end flag.
Chapter 18: Channelized T1 and T3 Interface Operational Mode Commands
Level of Output
extensive
All levels
All levels
extensive
769