ENVIRONMENTAL FINAL GOVERNING STANDARDS ITALY

More documents

Recommendations

Info

<strong>ITALY</strong> - 2 Air Emissions C2.3.6.8.2. Emergency releases for the legitimate purpose of fire extinguishing, explosion inertion, or other emergency applications for which the equipment or systems were designed. C2.3.6.8.3. Releases during the testing of fire extinguishing systems if each of the following is true: systems or equipment employing suitable alternative fire extinguishing agents are not available; release of extinguishing agent is essential to demonstrate equipment functionality; failure of system or equipment would pose great risk to human safety or the environment; and a simulant agent cannot be used. C2.3.7. Motor Vehicles. These criteria apply to DoD-owned motor vehicles as defined in the definitions section (C2.2.13.). C2.3.7.1. All vehicles shall be inspected every two years to ensure that no tampering with factory-installed emission control equipment has occurred. CO emissions for gasoline vehicles manufactured according to European specifications after 1986 will not exceed 3.5% in volume. For gasoline vehicles manufactured in Europe prior to 1986, the CO emission will not exceed 4.5% in volume. Motor vehicles manufactured according to European specifications and equipped with diesel engines will not exceed a 50% opacity (45% for buses). C2.3.7.2. Use only unleaded gasoline (with a maximum lead content of 0.013 g/L) in vehicles that are designed for this fuel. The maximum lead content for lead-bearing gasoline is 0.15 g/L. C2.3.8. Stack Heights. Hg is the good engineering practice stack height necessary to minimize downwash of stack emissions due to aerodynamic influences from nearby structures. C2.3.8.1. Stacks shall be designed and constructed to heights at least equal to the largest Hg calculated from either of the following two criteria: C2.3.8.1.1. Hg = H + 1.5L, where H is the height of the nearby structure measured from the ground level elevation at the base of the stack, and L is the lesser of height or projected width of the nearby structure(s). A structure is determined to be nearby when the stack is located within 5L of the structure envelope but not > 0.8 km (0.5 mile). This calculation shall be performed for each structure nearby the stack being studied to determine the greatest Hg. C2.3.8.1.2. Hg is the height demonstrated by a fluid model or a field study, which ensures that the emissions from a stack do not result in maximum ground-level concentrations of any air pollutant as a result of atmospheric downwash, wakes, or eddy effects created by the source itself, nearby structures, or nearby terrain features at least 40% in excess of the maximum ground-level concentrations of any air pollutant experienced in the absence of such atmospheric downwash, wakes, or eddy effects. For purposes of this paragraph, “nearby” means not > 0.8 km (0.5 mile), except that the portion of a terrain feature may be considered to be nearby, which falls within a distance of up to 10 times the maximum height (Ht) of the feature, not to exceed 3.2 kilometers (2 miles) if such feature achieves a height (Ht) 0.8 km from the stack that is at least 40% of the good engineering practice stack height determined by the formulae provided in C2.3.8.1.1. of this part or 26 meters (85.3 feet), whichever is greater, as measured from the September 2012 Italy FGS 2-10 Revision 0
<strong>ITALY</strong> - 2 Air Emissions ground-level elevation at the base of the stack. The height of the structure or terrain feature is measured from the ground-level elevation at the base of the stack. September 2012 Italy FGS 2-11 Revision 0
Page 1: ENVIRONMENTAL FINAL GOVERNING STAND
Page 4 and 5: ITALY Table of Contents Chapters Pa
Page 6 and 7: ITALY - 1 Overview C1.3.3. Operatio
Page 8 and 9: ITALY - 1 Overview C1.7. PERMITS AN
Page 10 and 11: This page intentionally left blank.
Page 12 and 13: ITALY - 2 Air Emissions C2.2.3.5.3.
Page 14 and 15: ITALY - 2 Air Emissions C2.2.22. Re
Page 16 and 17: ITALY - 2 Air Emissions waste or mu
Page 18 and 19: ITALY - 2 Air Emissions C2.3.5.1. A
Page 22 and 23: ITALY - 2 Air Emissions Table 2.1.
Page 24 and 25: ITALY - 2 Air Emissions Table 2.3-a
Page 26 and 27: ITALY - 2 Air Emissions Characteris
Page 28 and 29: ITALY - 2 Air Emissions Category of
Page 30 and 31: ITALY - 2 Air Emissions Category of
Page 32 and 33: This page intentionally left blank.
Page 34 and 35: ITALY - 3 Drinking Water drinking w
Page 36 and 37: ITALY - 3 Drinking Water C3.3. CRIT
Page 38 and 39: ITALY - 3 Drinking Water C3.3.1.7.1
Page 40 and 41: ITALY - 3 Drinking Water be require
Page 42 and 43: ITALY - 3 Drinking Water lead servi
Page 44 and 45: ITALY - 3 Drinking Water to meet DD
Page 46 and 47: ITALY - 3 Drinking Water d. For unf
Page 48 and 49: ITALY - 3 Drinking Water Population
Page 50 and 51: ITALY - 3 Drinking Water Table 3.3.
Page 52 and 53: ITALY - 3 Drinking Water Table 3.4-
Page 54 and 55: ITALY - 3 Drinking Water Contaminan
Page 56 and 57: ITALY - 3 Drinking Water Table 3.5-
Page 58 and 59: ITALY - 3 Drinking Water Parameter
Page 60 and 61: ITALY - 3 Drinking Water Parameter
Page 64 and 65: ITALY - 3 Drinking Water system and
Page 68 and 69: ITALY - 3 Drinking Water Table 3.11
Page 70 and 71:
ITALY - 3 Drinking Water Table 3.13
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
ITALY - 3 Drinking Water Notes: 1.
Page 80 and 81:
ITALY - 3 Drinking Water Parameter
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
ITALY - 3 Drinking Water Book of AS
Page 92 and 93:
ITALY - 4 Wastewater C4.2.9. Chemic
Page 94 and 95:
ITALY - 4 Wastewater C4.2.31.2. Fre
Page 96 and 97:
ITALY - 4 Wastewater Table 4.1.1-b:
Page 98 and 99:
ITALY - 4 Wastewater C4.3.1.6.3. Ur
Page 100 and 101:
ITALY - 4 Wastewater C4.3.1.9.1. An
Page 102 and 103:
ITALY - 4 Wastewater C4.3.2.2.2.1.
Page 104 and 105:
ITALY - 4 Wastewater C4.3.3.1. Elec
Page 106 and 107:
ITALY - 4 Wastewater C4.3.3.2. Moni
Page 108 and 109:
ITALY - 4 Wastewater C4.3.4.3.3. Fi
Page 110 and 111:
ITALY - 4 Wastewater Parameter Unit
Page 112 and 113:
ITALY - 4 Wastewater Parameter Unit
Page 114 and 115:
ITALY - 4 Wastewater For artificial
Page 116 and 117:
ITALY - 4 Wastewater Parameter # Pa
Page 118 and 119:
ITALY - 4 Wastewater Parameter # Pa
Page 120 and 121:
ITALY - 4 Wastewater Table 4.1.1-a.
Page 122 and 123:
ITALY - 4 Wastewater Table 4.1.2-b.
Page 124 and 125:
ITALY - 4 Wastewater Table 4.4. Com
Page 126 and 127:
ITALY - 4 Wastewater Table 4.7. Bes
Page 128 and 129:
ITALY - 4 Wastewater 1.4 Chemical i
Page 130 and 131:
ITALY - 4 Wastewater 3 Installation
Page 132 and 133:
ITALY - 4 Wastewater D1 Tipping abo
Page 134 and 135:
ITALY - 4 Wastewater Table 4.10. Ap
Page 136 and 137:
ITALY - 4 Wastewater (3) The above
Page 138 and 139:
ITALY - 5 Hazardous Materials C5.2.
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
ITALY - 5 Hazardous Materials adver
Page 146 and 147:
ITALY - 6 Hazardous Waste C6.2. DEF
Page 148 and 149:
ITALY - 6 Hazardous Waste quart) of
Page 150 and 151:
ITALY - 6 Hazardous Waste C6.2.30.6
Page 152 and 153:
Page 154 and 155:
ITALY - 6 Hazardous Waste complete
Page 156 and 157:
Page 158 and 159:
ITALY - 6 Hazardous Waste C6.3.8.1.
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
ITALY - 6 Hazardous Waste access by
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
ITALY - 6 Hazardous Waste can also
Page 172 and 173:
This page intentionally left blank.
Page 174 and 175:
ITALY - 7 Solid Waste USEUCOM Waste
Page 176 and 177:
ITALY - 7 Solid Waste hazardous was
Page 178 and 179:
ITALY - 7 Solid Waste C7.2.31.10. M
Page 180 and 181:
ITALY - 7 Solid Waste C7.2.37.5. Ya
Page 182 and 183:
ITALY - 7 Solid Waste C7.3.3.1.8. N
Page 184 and 185:
ITALY - 7 Solid Waste C7.3.6.3.1. D
Page 186 and 187:
ITALY - 7 Solid Waste must be at le
Page 188 and 189:
ITALY - 7 Solid Waste “Hazardous
Page 190 and 191:
ITALY - 7 Solid Waste Table 7.3. Ma
Page 192 and 193:
ITALY - 8 Medical Waste Management
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
ITALY - 9 Petroleum, Oil, and Lubri
Page 208 and 209:
ITALY - 9 Petroleum, Oil, and Lubri
Page 210 and 211:
Page 212 and 213:
ITALY - 11 Pesticides C11.2.7. Pest
Page 214 and 215:
ITALY - 11 Pesticides pesticides, t
Page 216 and 217:
ITALY - 12 Historic & Cultural Reso
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
ITALY - 13 Natural Resources and En
Page 224 and 225:
ITALY - 13 Natural Resources and En
Page 226 and 227:
Page 228 and 229:
ITALY - 14 Polychlorinated Biphenyl
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
ITALY - 15 ASBESTOS C15.3. CRITERIA
Page 238 and 239:
ITALY - 15 ASBESTOS C15.3.4.4. The
Page 240 and 241:
Page 242 and 243:
ITALY - 17 Lead-Based Paint C17.2.7
Page 244 and 245:
ITALY - 17 Lead-Based Paint C17.3.1
Page 246 and 247:
Page 248 and 249:
ITALY - 18 Spill Prevention and Res
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
ITALY - 19 Underground Storage Tank
Page 260 and 261:
ITALY - 19 Underground Storage Tank
Page 262 and 263:
Page 264 and 265:
ITALY - APPENDIX A List of Hazardou
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
Page 294 and 295:
Page 296 and 297:
ITALY - APPENDIX B.1 Characteristic
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
ITALY - APPENDIX B.4 Non-Hazardous
Page 304 and 305:
Page 306 and 307:
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
ITALY - APPENDIX B.5 Hazardous Wast
Page 314 and 315:
ITALY - APPENDIX B.6 Persistent Org
Page 316:
ITALY - APPENDIX C Determination of
show all

ENVIRONMENTAL FINAL GOVERNING STANDARDS ITALY

Create successful ePaper yourself

Delete template?

Save as template?