You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
added to the measured values of a channel to allow the option of modification of the desired<br />
measured value ranges in the diagram.<br />
In addition, the datalogger display parameters can be used to specify which recorded data value<br />
is to be displayed in the diagram as the "curve type" (maximum value, minimum value or average<br />
value). When a datalogger channel is displayed with differentials in the data value recording,<br />
it is not possible to select the curve type as there can only be one differential value displayed<br />
for each interval.<br />
A maximum of four display elements can be configured on a screen page as datalogger displays.<br />
A total of 50 datalogger displays can be created in the panel and distributed to different<br />
pages.<br />
i Within a diagram, the characteristic curve created from the data values runs from right to<br />
level parallel to the time axis.<br />
i If, within a period of time, no telegram could be received and evaluated, then the corresponding<br />
interval is considered "invalid". The characteristic curve is thus interrupted in the<br />
value-time diagram of the on-screen display.<br />
i In a diagram, the values of a datalogger channel are displayed, without reformatting, in the<br />
way that they are receive in the data telegram from the bus, providing that no reinforcement<br />
or offset is specified in the configuration of the curve. As a result, a data value, for example,<br />
received in the format DPT 5,001 (1 byte value) in a value range of 0...255 can be displayed<br />
in the diagram. If, in this example, percentage values should be displayed<br />
(e.g. command values), the data values can be reformatted by the reinforcement. In such a<br />
case, a 1 byte data value (0...255) with a reinforcement of "0.392" can be converted to a<br />
percentage data value (0...100 %). This reinforcement should then be entered in the parameter<br />
of the same name of the affected curve in the ETS plug-in.<br />
An offset causes a shift of the appropriate curve upwards on the Y axis (positive offset) or<br />
downwards (negative offset).<br />
Order-No. 7574 00 1X<br />
Software "...590101"<br />
Functional description<br />
Page 104 of 222