Master Control - Berker

Order-No. 7574 00 1X
play element on bit status "1" (switched
on).
This parameter is only visible with
"Status display = as icon" and "Display
format = bit-orientated".
Bit to be evaluated 0...7 The bit, to be evaluated to display a bitorientated
status display in the 1 byte
value, should be selected here.
This parameter is only visible in the data
format DPT 5,001 ... 5,004 and "Display
format = bit-orientated".
Offset 0 This parameter can be used to adapt the
value of the communication object to the
required format using a static offset
(positive or negative).
Amplification 1 This parameter can be used to adapt the
value of the communication object to the
required format using reinforcement
(multiplier).
Format #####.# This parameter can be used to specify
the format of the displayed value. Pressing
"..." can set the format using an editor,
using which the predefined standard
format can be changed through manual
inputs.
Unit % List of predefined units
Value alignment Left-align
Centred
Right-align
User-defined
This parameter can be used to specify a
unit for the format DPT 5,001 ... 5,004.
The unit is displayed immediately behind
the display value.
This parameter is invisible with "Value
display = DPT 5,001 ... 5,004 (1 byte)"
and in conjunction with "Value format =
bit-orientated".
This parameter defines the horizontal arrangement
of the status value within the
display element. In the "User-defined"
setting, an additional parameter is displayed
for precise positioning.
X position of the value 1 The alignment of the status value within
a display element is specified here. The
settable value depends on the width of
the display element.
Limit value monitoring No
Yes
Software "...590101"
Parameters
Two limit values (upper limit value /
lower limit value) are available for each
Page 158 of 222