Master Control - Berker

Order-No. 7574 00 1X
DPT 6,010 (1 byte –
counter with plus/minus
sign)
DPT 5,010 (1 byte -
counter)
Display format 0 … 255
0 … 100%
0...360°
User-defined
The display format of the value is
defined here.
This parameter is only visible with
"Value display =
DPT 5,001 ... 5,004(1 byte)".
Offset 0 This parameter can be used to adapt the
value of the communication object to the
required format using a static offset
(positive or negative).
Amplification 1 This parameter can be used to adapt the
value of the communication object to the
required format using reinforcement
(multiplier).
Format #####.# This parameter can be used to specify
the format of the displayed value. Pressing
"..." can set the format using an editor,
using which the predefined standard
format can be changed through manual
inputs.
Unit % List of predefined units
For "Date" function...
Source Internal
EIB
For "Time" function...
Source Internal
EIB
Software "...590101"
Parameters
This parameter can be used to specify a
unit for the format DPT 5,001 ... 5,004.
The unit is displayed immediately behind
the display value.
The displayed date is derived either
from the internal real time clock of the
panel or from an additional communication
object, i.e. from the KNX/EIB.
The displayed time is derived either from
the internal real time clock of the panel
or from an additional communication object,
i.e. from the KNX/EIB.
Offset [hours] -12...0...12 To adjust the time to various timezones,
the time can be corrected by a static
hour offset here.
Page 182 of 222