Master Control - Berker

Order-No. 7574 00 1X
This parameter defines the display text
in the third line of the service address.
Service address, line 4 No presetting The service page in area 2 can display
any service address which can be made
up of up to 5 lines.
This parameter defines the display text
in the fourth line of the service address.
Service address, line 5 No presetting The service page in area 2 can display
any service address which can be made
up of up to 5 lines.
This parameter defines the display text
in the fifth line of the service address.
h Service page -> Area 3
Heading [Administrator] Predefined page heading of the third
service area, which can be changed as
necessary.
Password level No password protection
Password level 1
Password level 2
Password level 3
Password level 4
If a password level is set here, then the
user must enter the correct password to
open the page, if the previous page has
a lower password level.
h Status line -> [Status element designation] - [Status element function] -> General
Designation [Status element] Predefined designation of the status element
which appears only in the node
name of the plug-in and which can be
modified as necessary.
h Status line -> [Status element designation] - [Status element function] -> Function
Function Event display
Collective fault message
Value
Date
Time, ASCII text
For "Event display"
function...
Display As text
As icon
Software "...590101"
Parameters
The function of the status element can
be selected here. The individual functions
mostly correspond to the display
element functions of the same name.
The event display corresponds to a display
element with the function "Switching".
The collective fault message is active
when at least one error fault message
has been activated. Different communication
objects are displayed according
to this selection.
The switching state can be displayed in
the status line, either as text or, alternat-
Page 180 of 222