Master Control - Berker

Sending the data values of the datalogger by e-mail message
If the datalogger channel is configured in the ETS plug-in, then the recorded data values can be
sent cyclically by e-mail. In this case, the panel prepares the recorded data in a CSV file and
sends it to a specified recipient in a standard e-mail. Both the e-mail function and the recipient
address can be configured in the ETS plug-in in the parameter group of a datalogger channel.
The e-mail is sent automatically each time the configured recording period of the appropriate
datalogger channel has elapsed (see chapter 4.2.4.10.1. Datalogger recording). The data forwarded
by e-mail thus take only the data values of one recording period into account.
i In addition to the transmission of the datalogger measurement values by e-mail, the data
values can be read out by the PC Client software and saved in a file (see chapter 4.3.1. Introduction,
installation and program start).
Order-No. 7574 00 1X
Software "...590101"
Functional description
Page 133 of 222