You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
i The set RSS newsfeed parameters are a component part of the opened project of the PC<br />
Client software. The settings in the project file are permanently saved, if the menu item<br />
"Save" or "Save as" is select in the "Project" menu.<br />
Write configuration data to device<br />
If, in the "Settings" menu, the "Write configuration data to device" item is opened, the PC Client<br />
software sets up an IP connection to the panel. All the IP parameters, the e-mail mailboxes settings<br />
and the RSS newsfeed data are then programmed into the device. The configuration data<br />
in the panel up to this moment is overwritten.<br />
i The configuration data are saved to the non-volatile memory of the device and then are<br />
available unchanged after a device reset.<br />
i For the PC Client software to program the configuration data successfully, the device connection<br />
settings (IP address of the panel and the communication port) must be set correctly<br />
in the PC Client software (see section "Device connection settings"). In addition, it is necessary<br />
to switch on the panel and connect it to the network. Should these preconditions not<br />
be complied with, it is not possible to program the configuration data and the PC Client<br />
software cancels the operation with an error message.<br />
During a programming operation, the communication status is displayed in colour on the<br />
bottom edge of the PC Client software window.<br />
i After a programming operation, the panel initialises and then works only with the new IP<br />
parameters. For the PC Client software to reconnect to the panel via the Ethernet interface,<br />
it is important to compare the device connection data with all the IP parameters. Otherwise<br />
the PC Client software will not be able to communication with the panel. This must especially<br />
be noted in the case of DHCP-administered networks.<br />
i If the configuration data of a panel currently in operation needs to be modified or tested,<br />
then the following menu sequence should be generally kept to...<br />
1. Load configuration data out of the device,<br />
2. Check or make IP settings,<br />
3. Check or make e-mail settings,<br />
4. Check or make RSS feed settings,<br />
5. Write configuration data to the device.<br />
i The set configuration parameters are a component part of the opened project of the PC Client<br />
software. All the settings in the project file are permanently saved, if the menu item<br />
"Save" or "Save as" is select in the "Project" menu.<br />
Order-No. 7574 00 1X<br />
PC Client software<br />
Configuration data (IP, e-mail, RSS)<br />
Page 217 of 222