Master Control - Berker

Curve 1 / 2:
Offset
Y axis:
Display axis title
Y axis
Axis title
Y axis: automatic scaling
Order-No. 7574 00 1X
the diagram.
i In a diagram, the values of a datalogger
channel are displayed,
without reformatting, in the way that
they are receive in the data telegram
from the bus, providing that
no reinforcement or offset is specified
in the configuration of the
curve. As a result, a data value, for
example, received in the format
DPT 5,001 (1 byte value) in a value
range of 0...255 can be displayed in
the diagram. If, in this example, percentage
values should be displayed
(e.g. command values), the data
values can be reformatted by the
reinforcement. In such a case, a 1
byte data value (0...255) with a reinforcement
of "0.392" can be converted
to a percentage data value
(0...100 %).
0 A static offset can be added to the
measured values of a channel to allow
the option of modification to the desired
measured value ranges in the diagram.
An offset not equal to "0" shifts the curve
along the Y axis in a positive or negative
direction.
Yes
No
The Y axis of the graphic display can be
overwritten with a text. This parameter
defines whether the text heading of the
Y axis should be displayed in the display
element.
[Y axis] The Y axis title is specified here. This
parameter is only visible when the axis
title of the Y axis is to be displayed.
Yes
No
Software "...590101"
Parameters
The Y axis can be scaled automatically
according to the values to be displayed
(specified by minimum and maximum
values of the recording period / "Yes"
setting) or, alternatively, can be permanently
configured in a value range
("No" setting). If the scaling of the Y axis
is fixed, and there is a data value outside
the specified minimum or maximum
limits, then the data value curve is
drawn in vertically upwards or downwards
from the two neighbouring data
points.
Page 164 of 222