Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4.2.4.13.3 Sending e-mail messages<br />
Sending e-mail messages<br />
The panel is able to send predefined texts as "event e-mails". The text contents of the event email<br />
as well as the recipient address are specified in the ETS plug-in by the project planner before<br />
the panel is commissioned. Sending of texts is triggered by switching telegrams, which receive<br />
either KNX/EIB group addresses or internal group addresses.<br />
Clicking the right mousebutton in the "e-Mail -> Event e-Mail" parameter node in the ETS plug-in<br />
allows the creation of up to 50 event e-mails. A 1 bit communication object "Send e-mail" is<br />
shown for each event e-mail.<br />
Within the parameter node of a event e-mail, the project planner specifies the following properties...<br />
- "Designation": identifying text, which is only displayed in the name of the parameter node of<br />
the event e-mail in the ETS plug-in.<br />
- "Send e-mail on": definition of the telegram polarity for the "Send e-mail" object of the corresponding<br />
event e-mail. The e-mail is sent when a telegram is received with the polarity<br />
defined at this point. Telegrams with another polarity are rejected.<br />
- "Subject": specification of the subject text of the event e-mail (e.g. "Signalling system fault",<br />
"Heater frost protection", etc.). The text may be a maximum of 20 characters in length.<br />
- "Contents": specification of the the text contents of the event e-mail. A maximum of 60<br />
characters can be entered. It is not possible to enter a line break or other formatting. The<br />
specified contents text is later transmitted to the mail server as 'plain text' in the event email,<br />
and is displayed in the same manner, without special formatting, when the message<br />
is opened.<br />
- "Recipient": specification of the e-mail address of a recipient of the event e-mail. Up to five<br />
recipients can be specified for each e-mail. The event e-mail is sent simultaneously to all<br />
the recipients entered.<br />
The standard input format of the address is specified as "local@domain"<br />
(example: "xxx@yyy.de"). The maximum address length is 58 characters.<br />
The contents text of an event e-mail specified in the ETS plug-in is always replaced by an automatic<br />
text. The recipient of the event e-mail would always read the following additional note at<br />
the end of the contents...<br />
"This message was generated automatically. Date: dd.mm.yyyy Time: hh:mm"<br />
To enable the panel to send e-mails, a valid SMTP mail server (Simple Mail Transfer Protocol)<br />
must be entered in the device configuration. The SMTP configuration is carried out in the PC<br />
Client software (see chapter 4.3.1. Introduction, installation and program start).<br />
i After a device reset (return of mains power supply, programming operation), the panel first<br />
initialises the Ethernet interface. e-mails can only be sent when this initialisation operation<br />
has been completed (if necessary using DHCP). After a device reset, this is usually possible<br />
after 1 minute at the latest.<br />
i The panel always sends the text characteristics of an e-mail messages using the system<br />
character set set in the ETS plug-in (Windows codepage).<br />
Order-No. 7574 00 1X<br />
Software "...590101"<br />
Functional description<br />
Page 132 of 222
Change language