Master Control - Berker

Order-No. 7574 00 1X
picture 33: Page for selecting the channel of the presence simulation.
Software "...590101"
Functional description
At this point, the user sees the 32 functions (recording objects) created in the ETS plug-in. The
user can now select up to 15 functions and include them in the presence simulation. The selections
are made directly by tapping the appropriate function button on the screen. A function selected
for the presence simulation is indicated by an "X" in the function button behind the function
designation. Tapping the function button again deselects the function. In the same way, the
state "Selected" or "Not selected" can be influenced using the "Activate / Deactivate" button.
After pressing the "Save back" button, the selection is saved in the panel and the panel jumps
back to the system page of the presence simulation. Pressing the "Cancel back" button simply
causes a jump back to the presence simulation page without saving the user configuration.
By changing the channel selection, the user can, at any time, change the functions included in
the presence simulation and, if the situation requires, adapt it to special requirements.
i The channel selection is only saved temporarily in the RAM of the panel, meaning that a
new selection is required (every function deactivated) and resaving is required after a
power failure or a programming operation.
i If the function selection is changed and resaved after a simulation has been recorded, then
the previous recording is deleted. The operator must then record a new simulation (see
next section).
Recording a telegram sequence
After the operator has selected the functions of the presence simulation, the telegram sequence
can be recorded. For this, the operator must first specify a maximum recording period in days.
Usually, a simulation recording takes place independently in the background. The length of the
recording period can be used to specify when the simulation recording stops automatically after
starting. Independently of this, a recording can also be stopped manually at any time (see below).
The length of the recording period can be edited using the on-screen numeric keyboard after
tapping the "Length:..." button. Periods of 1 ... 7 days can be configured.
A day is not a calendar day but a 24 hour period. Example: if the recording begins on Tuesday
at 9:00, the first day of the recording will end on Wednesday at 8:59. The start time of the recording
thus specifies the start of a day, i.e. of a 24 hour period.
Before starting recording, ensure that the time and weekday on the panel is set correctly!
Page 106 of 222