Master Control - Berker

4.2.4.9 Multiplexer
The panel has the ability to create up to 12 multiplexer functions. To add a multiplexer to the
project planning, the parameter node "Logic -> Multiplexer" should be selected in the tree structure
of the ETS plug-on and executed by clicking the right mousebutton on the command "Add
multiplexer". For added clarity, each multiplexer is given a designation in the ETS plug-in, which
can be changed by the project planer using the parameter of the same name.
A multiplexer forwards the value of an input object to one of two or one of four outputs. The output
used depends on the status of the control input (one to two) or one of the two control inputs
(one to four). Each multiplexer of the panel can contain up to three channels, which can be controlled
by the same control inputs and added by clicking the right mousebutton. Within a channel,
the input and the outputs have the same object type. The following data formats are support,
and can be configured using the parameter "Object type input / outputs" for each channel:
DPT 1,001 (switching, 1 bit), DPT 3,007 (dimming, 4 bit), DPT 9,001 ... 9,0021 (value, 2 byte),
DPT 5,001 ... 5,004 (rel. value, 1 byte), DPT 14,000 ... 14,079 (IEEE float, 4 byte),
DPT 7,001 / 8,001 (counter, 2 byte), DPT 12,001 / 13,001 (counter, 4 byte),
DPT 16,001 / 16,002 (ASCII characters, 1 byte), DPT 5,010 (counter, 1 byte).
The following truth tables and figure describe the internal function of the multiplexers according
to the function "1 to 2 multiplexer" or "1 to 4 multiplexer".
Order-No. 7574 00 1X
picture 29: Multiplexer "1 to 2"
Control input 1 Forwarding to
0 Output 1
1 Output 2
Table 9: selection of the output by control input for multiplexer "1 to 2"
Software "...590101"
Functional description
Page 97 of 222