Master Control - Berker

Icon for
frost / heat protection
Icon for
automatic operation
Value alignment Left-align
Centred
Right-align
User-defined
Order-No. 7574 00 1X
No presetting An icon can be configured here for active
frost/heat protection.
This parameter is only visible with
"Status display = as icon".
No presetting An icon can be configured here for active
automatic operation.
This parameter is only visible with
"Status display = as icon" and "Operating
mode switch via = Connex".
This parameter defines the horizontal arrangement
of the status display within
the display element. In the "Userdefined"
setting, an additional parameter
is displayed for precise positioning.
X position of the value 1 The alignment of the status display within
a display element is specified here.
The settable value depends on the width
of the display element.
For display function
"Collective feedback"...
Channel to be evaluated
1...16 Here, there must be a definition of which
channel bit is to be evaluated in the collective
feedback. Only the channel
defined here is taken into account in the
status display of the effected display element.
Status display As text
As icon
Image text for
'On' status
Image text for
'Off' status
Image text for
'Invalid' status
Software "...590101"
Parameters
The switching state can either be displayed
by an image text or a status icon.
[On] When a channel is switched on, the image
text defined here is displayed.
This parameter is only visible with
"Status display = as text".
[Off] When a channel is switched off, the image
text defined here is displayed.
This parameter is only visible with
"Status display = as text".
[Invalid] If the channel specified in the "Channel
to be evaluated" parameter is not in-
Page 169 of 222