Medium Access Control (MAC) and Physical Layer (PHY) - CISE

4-June-07 P1901_PRO_016_r0
8.2.4 Service reliability
This parameter defines if the ACK mode is enabled (see section 5.4) within the service class.
8.2.4.1 Configuration
Mapping Service Reliability to a priority: Such a mapping shall be declared within each master by using the
QOS_PRIOACK.prio+1 parameter.
8.2.5 Example of a service class definition
The service class definition shall be the same for all nodes in the BPL cell, and must determine univocally the the
relationship between priority, maximum subcell access time, resource reservation and service reliability
characteristics.
This service class definition must be used by QoS to determine the priorization between flows and resources
reservation in the network, and will provide criteria to allow or deny new flows or to drop existent flows to allow
new flows which higher service class.
Table 18 shows an example of possible relationship between service classes, priorities, Max_Subcell_Access_Time,
Service Reliability and Resource Reservation Type.
Submission page 181 UPA-OPERA