Medium Access Control (MAC) and Physical Layer (PHY) - CISE

4-June-07 P1901_PRO_016_r0
o Parameter: This list enables (1) or disables (0) the Layer 2 ACK protocol depending on the
priority level transmitted by the modem (priority levels: prio = 0 … 7).
• QOS_PRIORSV.prio+1 = [CBR | VBR | BE]
o Parameter: Type of reservation for each priority
12.3.3.5.1 Slave Node Parameters (CPE)
• QOS_UPBWLIMIT = [YES | NO]
o Parameter: Enables (YES) or disables (NO) the transmission bandwidth limitation in a slave.
• QOS_CLASSES.prio+1 = [VOIP | VIDEO | DATAH | DATAL]
o Parameter: Sets the type of application for each service class
12.3.3.5.2 Master Node Parameters (HE or REPEATER)
• QOS_LATENCY_STEP = [20 … 400]
o Parameter: Values in ms, from 20 to 400.
• QOS_BW_POLICY = [0 | 1]
o Parameter: A value of 0 corresponds to Fair mode, and 1 to Priority-based mode.
• QOS_LATENCY.prio+1 = [1 | 2 | 4 | 8]
o Parameter: Priority levels: prio = 0 … 7. Possible values are: 1, 2, 4 and 8.
12.3.3.6 Profiles Parameters
• PROFILE_MAX_TXPUT_TX.i = dddd (in kbps)
o Parameter: Number of kbps)
• PROFILE_MAX_TXPUT_RX.i = dddd (in kbps)
o Parameter: Number of kbps)
• PROFILE_PRIORITIES.i = [0x00-0xFF]
o Parameter: ‘0xXX’ (hexadecimal number from 00 to FF)
• PROFILE_MNMT_VLAN.i = [2-4093] | %
o Parameter: Number from 2 to 4093 or ‘%Parameter_name’ (parametric value preceded by a %)
• PROFILE_DATA_VLAN.i = [2-4093] | %
Submission page 381 UPA-OPERA