Medium Access Control (MAC) and Physical Layer (PHY) - CISE

4-June-07 P1901_PRO_016_r0
Busy tone configuration pattern. Please see section 11.12.3 for details.
• VOIP_TONE_RINGBACK = freq1@pot1+freq2@pot2#ON(time),OFF(time),IDLE(time),R
o Parameter: This parameter is a string (up to 70 characters) (e.g. “VOIP_TONE_RINGBACK =
425@-10#ON(1500),OFF(3000),R”).
o SNMP: no
o Mandatory: no
Ring-back tone configuration pattern. Please see section 11.12.3 for details.
• VOIP_RTP_TOS = 0xXX
o Parameter: value must be specified with 2 hexadecimal digits.
o SNMP: no
o Mandatory: no
Configures the 8-bit bitmap of the type of service field in the IP header of the RTP packets.
• VOIP_CALLSIG_TOS 0xXX
o Parameter: value must be specified with 2 hexadecimal digits.
o SNMP: no
o Mandatory: no
Configures the 8-bit bitmap of the type of service field in the IP header of the VoIP signalling packets for
H.323.
11.12.1 Dial Plan Configuration
A dial plan gives the unit a map to determine when a complete number has been entered and should be passed to the
gatekeeper for resolution into an IP address. Dial plans are expressed using the same syntax used by MGCP NCS
specification.
The dialled numbers that do not match the specified dial plan do not initiate an outgoing call from the VoIP modem.
The formal syntax of the dial plan is described using the following notation:
Digit ::= "0" | "1" | "2" | "3" | "4" | "5" | "6" | "7" | "8" | "9"
Submission page 322 UPA-OPERA