Medium Access Control (MAC) and Physical Layer (PHY) - CISE

4-June-07 P1901_PRO_016_r0
plQoS
• plMACTable
o plMACCard: Card index.
o plMACAccessProtocol: Enables/disables the Access Protocol mode, which has been implemented
to allow a node to automatically learn the MAC addresses of the nodes that are liable to connect
with it.
o plMACNumConnectedNodes: Shows the number of nodes successfully connected, that is, with its
link solved by the Port Solver Protocol.
o plMACNumSlaves: Shows the number of configured slaves if the nodeis a master.
• plMACConnectedNodesTable
o plMACConnectedNodesCard: Card index.
o plMACConnectedNodesIndex: This index will refer to a connected node, a number ranging from
0 to the value shown by plMACNumConnectedNodes (see above).
o plMACConnectedNodesMAC: MAC address of the indexed connected node.
• plMACSlavesTable
o plMACSlavesCard: Card index.
o plMACSlavesIndex: This index will refer to a slave node, a number ranging from 0 to the value
shown by plMACNumSlaves (see above).
o plMACSlavesMAC: MAC address of the indexed slave node.
• plQoSMasterGeneralMinOneWayLat
If the modem is a master, this OID shows the minimum latency configured in the modem in milliseconds.
• plQoSMasterGeneralBwMngrPolicy
This OID shows the policy to be followed by a master in assigning a certain bandwidth to its attached
slaves. If a 0 is returned, the master is configured to assign bandwidth in a fair policy, while if a 1 is
returned, the bandwidth is assigned in a priority-based policy.
• plQoSPriorityManagementTable
o plQoSPriorityManagementCard: Card index.
o plQoSPriorityManagementPrio: Priority value, from 1 to 8.
Submission page 355 UPA-OPERA