Medium Access Control (MAC) and Physical Layer (PHY) - CISE

4-June-07 P1901_PRO_016_r0
• VOIP_TONE_RINGBACK = freq1@pot1+freq2@pot2#ON(time),OFF(time),IDLE(time),R
o Parameter: This parameter is a string (up to 70 characters) (e.g. “VOIP_TONE_RINGBACK =
425@-10#ON(1500),OFF(3000),R”).
• VOIP_RTP_TOS = 0xXX
o Parameter: value must be specified with 2 hexadecimal digits.
• VOIP_CALLSIG_TOS 0xXX
o Parameter: value must be specified with 2 hexadecimal digits.
12.3.3.13 NTP Parameters
• NTP_ENABLE = [ENABLED | DISABLED]
o Parameter: Enables (ENABLED) or disables (DISABLED) the NTP feature.
• NTP_SERVER_IP =
o Parameter: The valid format is the dotted decimal notation (four decimal numbers separated by
dots).
• NTP_TIMEZONE = [-12 … 12] * 60
o Parameter: This value must be specified in minutes (in 60-minute steps) relative to Universal
Time (UT). A value of 0 corresponds to UT.
• NTP_DST = [YES | NO]
o Parameter: If the value is YES, the time correction for daylight savings time is applied. Not
applied if NO.
12.3.3.14 Custom VLAN/OVLAN Parameters
• USE_CUSTOM_VLAN_OVLAN = [yes/no]
o Parameter: ‘yes’ (to enable the custom VLAN/OVLAN use) or ‘no’ (to disable the custom
VLAN/OVLAN use)
• VLAN_TAGGED_ONLY_IFACE_ROOT = [yes/no]
o Parameter: ‘yes’ (to enable tag only in interface root) or ‘no’ (to disable tag only in interface root)
• VLAN_TAGGED_ONLY_IFACE_EXTA = [yes/no]
o Parameter: ‘yes’ (to enable tag only in Ethernet A) or ‘no’ (to disable tag only in Ethernet A)
• VLAN_TAGGED_ONLY_IFACE_EXTB = [yes/no]
o Parameter: ‘yes’ (to enable tag only in Ethernet B) or ‘no’ (to disable tag only in Ethernet B)
Submission page 389 UPA-OPERA