Medium Access Control (MAC) and Physical Layer (PHY) - CISE

4-June-07 P1901_PRO_016_r0
o SNMP: no
o Mandatory: yes
This parameter indicates the priorities allowed for a user of profile i. This is useful to prioritise some
transmission above others and to give some quality of service to the different modems.
At this parameter each bit represents a priority, that can be set or not. The default value is 0x85, so
priorities 7, 2 and 0 are allowed. To include another priority, it is necessary to set the appropriate bit in the
profile priorities flag. In any case, the maximum and minimum priorities are always set even if they are not
configured (0x81).
• PROFILE_MNMT_VLAN.i = [2-4093] | %
o Parameter: Number from 2 to 4093 or ‘%Parameter_name’ (parametric value preceded by a %)
o SNMP: no
o Mandatory: yes
If VLANs are used, this value indicates the management VLAN for that user.
• PROFILE_DATA_VLAN.i = [2-4093] | %
o Parameter: Number from 2 to 4093 or ‘%Parameter_name’ (parametric value preceded by a %)
o SNMP: no
o Mandatory: yes
If VLANs are used, this value indicates the Data VLAN for that user.
• PROFILE_VOIP_VLAN.i = [2-4093] | %
o Parameter: Number from 2 to 4093 or ‘%Parameter_name’ (parametric value preceded by a %)
o SNMP: no
o Mandatory: no
If VLANs are used, this valued indicates the VoIP VLAN for that user.
• PROFILE_VLAN_ADD_TAG.i.j = [2-4093] or parametric
o Parameter: Number from 2 to 4093 or ‘%Parameter_name’ (parametric value preceded by a %)
o SNMP: no
o Mandatory: yes
Submission page 306 UPA-OPERA