Medium Access Control (MAC) and Physical Layer (PHY) - CISE

4-June-07 P1901_PRO_016_r0
• GENERAL_COMMON_STP_EXTB = [YES | NO]
Parameter: Enables (YES) or disables (NO) the Common STP feature in the Ethernet interface B (EXTB).
SNMP: no
Mandatory: no
Enables or disables the Common STP feature in the Ethernet interface B (EXTB). This parameter only makes
sense to be used if VLANs are enabled. If it is enabled, STP packets will be released and accepted through
EXTB without VLAN tag (even if VLANs are enabled). If it is disabled, STP packets will be released with the
management VLAN tag (if VLANs are active).
WARNING: with this parameter enabled, all packets without VLAN will be accepted through EXTB.
• GENERAL_IP_ADDRESS =
Parameter: The valid format is the dotted decimal notation (four decimal numbers separated by dots).
SNMP: plSysStaticIPAddress
Mandatory: no
Configures the IP address to be used when booting up with DHCP disabled.
• GENERAL_IP_NETMASK =
Parameter: The valid format is the dotted decimal notation (four decimal numbers separated by dots).
SNMP: plSysStaticNetMask
Mandatory: no
Configures the IP network mask to be used when booting up with DHCP disabled.
• GENERAL_IP_GATEWAY =
Submission page 297 UPA-OPERA