MOSAIQ User's Guide - UCSF Radiation Oncology

MOSAIQ User’s Guide
4. In the Sequencer SL ID group, click adjacent to the Setup Offset Reference field, then
click Patient or Isocenter.
5. In the Tx Images group, click the Enable Image Underlay check box if it is not
checked.
6. Click OK to close the Department Setup dialog box.
Configuring the Digitized Film Import (DFI) Option
Power on the scanner before you power on your MOSAIQ workstation. If
you fail to do so, MOSAIQ will not detect the scanner.
1. Launch MOSAIQ on a workstation connected to a film scanner.
2. Log on with your username and password.
3. Click File | Import/Export | DFI Configuration… to open the DFI Configuration
dialog box.
The General tab appears by default.
4. Click in the Machine field.
5. Click the name of the machine on which the film may have originated.
Click Unspecified if the images were not taken on a machine defined in
your system.
6. Type the source-to-axis distance in centimeters for the selected machine in the SAD field.
7. Type the source-to-film distance in centimeters for the selected machine in the SFD field.
8. Click in the Pixel Size Type field, then click SFD, which is typically for simulator or
other films, or Actual if you wish to specify the actual pixel size on the film as the type
of pixel size.
9. Click in the Image Type field, then click the type of images acquired at the selected
machine.
10. Click the Review Required check box if images acquired on the selected machine
should be reviewed by the physician.
11. Click Setup to save the Film Information Settings you have configured for the selected
machine.
Click Reset to use the system default values as the Film Information
Settings for the selected machine.
140 Copyright 2010, Elekta Impac Software
LUGMSQ0002/4.0/23-Sep-2010