MOSAIQ User's Guide - UCSF Radiation Oncology

CHAPTER 7: Image Management-ViewStation & Photos and Diagrams
5. Click that the Review Required check box if the image requires a physician’s review.
If the film is already signed by the physician, do not select this
check box.
6. Place the film in the scanner.
The scanning process starts immediately. The scanning status changes for each step in
scanning process and the image appears in the thumbnail box when the scanning is done.
If you scan an image upside down or backwards, you can cancel the
process and scan the image again, or you can flip or rotate the
image later.
7. If you wish to associate the scanned image with a treatment field, click Field in the
Association group.
CAUTION
You must associate the simulation image with a treatment field to
show the image with the treatment geometry in the Image
window, Treatment Field Definition dialog box, and Beam’s Eye
View dialog box.
8. Click adjacent to the Field list, then click the field with which to associate the image.
Figure 26 shows an example of treatment fields listed in the Field list.
Figure 26: Field List
The fields must already exist for the patient. You cannot create
them at this time.
9. If you wish to associate the scanned image with a prescription site, click Site in the
Association group.
10. Click adjacent to the Site list, then click the prescription site with which to associate
the image.
11. If you wish to associate the scanned image with a patient, click Patient in the
Association group.
Copyright 2010, Elekta Impac Software 145
LUGMSQ0002/4.0/23-Sep-2010