MOSAIQ User's Guide - UCSF Radiation Oncology

CHAPTER 7: Image Management-ViewStation & Photos and Diagrams
Figure 38: Image Registration Editor Window
In this window, you must first specify the curves, fiducial points, or registration region
by selecting the Image Registration method you want to use before you register the
images. The remaining steps explain how to do this for the Point and Curve Registration
methods.
If you need to change points or curves on a locked reference image,
you can copy the image in the Image List window. Refer to Copying
images from the Image List window on page 163. The copied image
is unlocked. Make your changes to the new image, then click the Use
for Tx Definition check box in the Image window.
Make sure to consider your maximum portal image exposure area.
Add your points and curves within this area.
4. Click the Point Registration check box in the Image Registration Methods group to
apply points to the image.
5. Click from the tool palette.
6. Put the red X where you want a point and click to set the first point. MOSAIQ
automatically gives points labels.
Copyright 2010, Elekta Impac Software 195
LUGMSQ0002/4.0/23-Sep-2010