MOSAIQ User's Guide - UCSF Radiation Oncology

MOSAIQ User’s Guide
12. Type a name for the image in the Image Name field.
13. Click Save to save the image and your configurations.
The Status field shows Saving image… while MOSAIQ writes the image file, then Image
saved when the image file is written to the staging area.
14. Click eCHART | Images… to open the Image List window and verify that the scanned
image was imported.
Acquiring Images from Electronic Sources
You can capture images directly from your simulator, electronic portal imager, or other
electronic devices. When you acquire an image from an electronic source, the image is
imported into MOSAIQ, and you can automatically associate it with the correct treatment
field, prescription site, or patient name. If the imported image is not associated or you wish
to change the association, you must associate the image to use it effectively during treatment
planning.
CAUTION
To associate an image with a patient, you must use the same patient
ID in both the image acquisition system and MOSAIQ.
1. Prepare your simulator or accelerator for imaging.
2. Capture an image using your device, then export the image to the Namer staging area set
up for the device.
3. Open the chart for your patient.
4. Click eChart | Images… to open the Image List window.
The image is imported directly into the patient chart and added to the Image List
window.
5. If you wish to associate the image with a treatment field or prescription site, click the
image captured from your imaging device, then click Open to open the Image window.
6. Right-click or press F4, then click Image Information to open the Image Information
window.
7. If you wish to associate the image with a treatment field, click the Field radio button,
then click the field you wish to associate with the image.
CAUTION
You must associate the simulation image with a treatment field to
see the image with the treatment geometry in the Image window,
Treatment Field Definition dialog box, and Beam’s Eye View dialog
box.
146 Copyright 2010, Elekta Impac Software
LUGMSQ0002/4.0/23-Sep-2010