MOSAIQ User's Guide - UCSF Radiation Oncology

MOSAIQ User’s Guide
7. Repeat step 7 until you have all the points you want.
8. If you want to move a point, select .
Notice that the points turn green when you place over them.
9. Click and drag the point with to the position you want.
10. Click the Curve Registration check box to draw curves with the Points, Curves, or
Registration Region tool.
11. Put the red X where you want to start the curve, then click and drag to draw the
curve.
Refer to Figure 39 for example of the curve drawn on the image.
Figure 39: Example of Curve
12. Continue drawing curves until you have all the curves you want.
13. Right-click and drag it back over a point or curve to erase them.
14. Click Save in the Image Registration Editor window.
15. Click OK to save your changes in the Image Registration Editor window and close the
Image window.
196 Copyright 2010, Elekta Impac Software
LUGMSQ0002/4.0/23-Sep-2010