MOSAIQ User's Guide - UCSF Radiation Oncology

CHAPTER 10: SEQUENCER
6. Click the In-Patient check box to change inpatient or outpatient status for this treatment
session from the inpatient/outpatient status defined in Patient Demographic Data.
7. Type your notes in the Note group.
8. Click Record to complete recording of the site setup.
Patient Verification
You can use Right Patient, Right Site, Right Technique in Site Setup Verification. When you
verify the patient, you can use a patient barcode or enter one or more electronic signatures.
You can configure how many and which signatures are necessary from the Department
Setup.
CAUTION
To use Site Setup Verification, you must have Clinical | Tx Delivery |
Modify or Approve rights.
1. In the Site Setup Verification window, click Patient Verification hyperlink to open the
Manual Patient Verification window.
This window lets you verify the patient setup with staff approvals. The Manual Patient
Verification window shows information about the Patient and the Patient ID Photo to
make sure you treat the correct patient. You can add comments for this treatment session
in the Note group. The Approval group shows the required and optional site setup
approvals, up to a maximum of 3. Optional approvals appear in italics.
2. In the Patient Verification Approval group, the logged in user name appears by default.
Type your password, then click Approve.
Your signature appears in the Approvals group.
3. Click Close to close the Manual Patient Verification window.
The Manual Patient Verification remains open until all required
signatures are entered.
Copyright 2010, Elekta Impac Software 269
LUGMSQ0002/4.0/23-Sep-2010