MOSAIQ User's Guide - UCSF Radiation Oncology

MOSAIQ User’s Guide
Overrides
The Site Setup Verification window shows all the parameter mismatches in red color. A
mismatch occurs when the actual value of a parameter is either out of tolerance or is not an
exact match to its prescribed value. The Overrides window lets you to clear all the parameter
mismatches to continue with the current treatment workflow.
CAUTION
To override a parameter mismatch, you must have Clinical | Tx
Delivery | Approve rights.
1. In the Site Setup Verification window, click Override to open the Overrides window.
The Override Parameters group shows all parameters that you can override.
2. Click the parameter check box or press SPACEBAR for the highlighted selection to
override the parameter that is out of tolerance.
3. Type your notes in the Note group.
4. In the Override Approval group, the logged in user name appears by default. Type your
password, then click OK.
5. Click Close to close the Overrides window.
Treatment Delivery
Field Sequencing
MOSAIQ lets you sequence treatment fields on the Treatment Calendar (refer to, Scheduling
AFS Sessions and Scheduling MFS Treatment Sessions in Chapter 4 on pages 122. You can
configure Automated Field Sequences (AFS) and Manual Field Sequences (MFS).
Automatic Field Sequences and Manual Field Sequences
The Treatment Delivery Table dialog box shows AFS or MFS sequences. Each field that is
part of a sequence shows the current field number in the sequence and the total number of
fields in the sequence. When multi-segmented IMRT fields are part of an AFS, each segment
in the treatment field becomes a single segment in the overall sequence. If you change a field
in an AFS from the Treatment Delivery Table, then the AFS sequence becomes invalid for
that session. You can treat the fields in the sequence as non-sequenced fields in the session.
Select the first field in the sequence to start an AFS or MFS sequence treatment. If you do not
select the first field in an AFS sequence, MOSAIQ shows a "Treat Sequence Out of Order?"
message. If you click Yes, then the Verified Treatment window opens for that field. If you
treat the field, then the AFS sequence becomes invalid for that session. You can treat the
remaining fields in the sequence as non-sequenced fields in the session.
270 Copyright 2010, Elekta Impac Software
LUGMSQ0002/4.0/23-Sep-2010