MOSAIQ User's Guide - UCSF Radiation Oncology

CHAPTER 7: Image Management-ViewStation & Photos and Diagrams
5. Click adjacent to the Filter field, then click Shadow Filter to apply the Shadow filter.
Notice that the image appears 3-D embossed and that the image shifts in the window as
filter is applied (and removed).
6. Click adjacent to the Filter field, then click None to remove the applied filters.
7. Click OK to save your changes, or click Cancel to close the Image window without
saving the changes.
Using Image Controls for Multi-Slice Images
When viewing and enhancing images that have multiple slices (called multi-slice images),
additional window and level and display controls are available. Refer to Figure 32.
Figure 32: Image Controls for Multi-Slice Images
Notice that the Apply to W/L to all check box is checked. When the check box is
checked, the image slices have the same contrast (window) and brightness (level).
Uncheck this check box to change the window and leveling for the image slice shown
only.
1. In the Image List window, double-click a multi-slice image.
2. Click the Apply W/L to all check box to de-select it.
3. Click and drag the right red bar of the Window and Level tool slowly to the far right to
lengthen the grayscale and brighten the center of the image for the slice displayed only.
4. Click and drag the yellow bar to attain the desired brightness or detail to change the
brightness in the window center.
5. Click in the slice series display controls to show the next slice in the sequence.
6. Click to automatically start showing the slices in the sequence.
7. Click to increase the speed of the display sequence.
8. Click to decrease the speed of display sequence.
9. Click to stop the automatic display.
Copyright 2010, Elekta Impac Software 171
LUGMSQ0002/4.0/23-Sep-2010