MOSAIQ User's Guide - UCSF Radiation Oncology

MOSAIQ User’s Guide
Using the Verified Treatment Window
The Verified Treatment window shows all prescription parameters as well as the actual
parameter values as read by the machine interface (if available). Parameters that are out of
tolerance appear highlighted in red. You can change between the two display modes with the
Tx Field/Field Setup button. This dialog box is the point in the process from which to start
a treatment.
CAUTION
You must have Clinical | Tx Delivery | Modify security rights to record
treatments. You must have Clinical | Tx Delivery | Approve to
approve treatment delivery information, complete partial
treatments, and override out of tolerance parameters. You must also
have Clinical | General | Approve rights to start standby mode.
Once you record the treatment, the system adds the dose delivered and shows the cumulative
amount in the Dose Site Summary. If the Dose Site Summary is open, then the dose
information is updated the next time the summary appears.
Using the Different Verified Treatment Views
The Verified Treatment window has different views.
1. In the Verified Treatment window, click Field View >.
The In-Room view has large fonts so that the information is easier to see. The
information that a therapist is most likely to need appears in the larger font size. It also
shows the treatment parameters and set up instructions.
2. From the In-Room view of the Verified Treatment window, click Field View >.
You can also right-click or press F4, then select Setup View.
The information in the Setup view matches what you would see in the Tx Field view of
the Treatment Field Definition dialog box. It shows notes from the radiation prescription
and field setup. Diagrams and/or field setup images, appear to the left of the Field Setup
and Rx Site groups (this depends on your Photos and Diagrams configuration, refer to
Using the Photos and Diagrams Utility in Chapter 6 on page 149.
3. In the Setup view of the Verified Treatment window, click Field View >.
You can also right-click or press F4, then select Full Field View.
This shows the Full Field view of the Verified Treatment window. This is the same view
as when you selected the field for treatment.
Your System Administrator can configure MOSAIQ so that one of
these views appears by default, such as the In-Room view.
272 Copyright 2010, Elekta Impac Software
LUGMSQ0002/4.0/23-Sep-2010