MOSAIQ User's Guide - UCSF Radiation Oncology

CHAPTER 7: Image Management-ViewStation & Photos and Diagrams
Setting Beam’s Eye View Preferences in the Field Definition
1. If you wish to set the viewing preferences for the MLC beam geometry and graticule in
the Beam’s Eye View, click eChart | Diagnoses and Interventions… to open the
Diagnoses and Intervention window.
2. Double-click the MLC treatment field associated with the image to open the Treatment
Field Definition dialog box.
3. Right-click or press F4, then place your mouse pointer over Preferences.
4. Click the MLC beam geometry viewing preference you wish to set.
The preferences are as follows:
View MLC
Edge
View MLC
Aperture
Shows the MLC edge only, providing the clearest view of
surrounding anatomy. This is the default view.
Shows the MLC aperture, which shows the MLC interleaf lines
within the jaw boundaries.
View MLC All Shows all the MLC leaves.
5. Click View Graticule if you want the graticule shown when you open the Image
window and/or Beam’s Eye View dialog box.
6. Click OK in the Treatment Field Definition dialog box to save the preference you set,
then click Close in the Diagnoses and Interventions window.
Setting Beam’s Eye View Preferences in the Image Window
1. If you wish to set the viewing preferences for the MLC beam geometry and graticule in
Image window, click eChart | Images… to open the Image List window.
2. Double-click an image associated with an MLC treatment field to open the Image
window.
3. Right-click or press F4, then place your mouse pointer over Preferences.
4. Click View Graticule if you want the graticule shown when you open the Image
window and/or Beam’s Eye View dialog box.
5. Right-click or press F4, place your mouse pointer over Preferences, then click the MLC
beam geometry viewing preference you wish to set.
Refer to Step 4 of Setting Beam’s Eye View Preferences in the Field Definition for more
information on MLC beam geometry viewing preferences.
6. Click OK to save your changes and close the Image window.
Copyright 2010, Elekta Impac Software 143
LUGMSQ0002/4.0/23-Sep-2010