MOSAIQ User's Guide - UCSF Radiation Oncology

MOSAIQ User’s Guide
Require
Session
Approval for
Treatment
(check box)
Require Tx
Plan Approval
for Treatment
(check box)
Require Tx
Calibration
Approval for
Treatment
(check box)
Portal Image
Check (check
box)
Dose
Tracking
Check (check
box)
Select so radiation treatment sessions must be approved before
MOSAIQ permits treatment.
MOSAIQ interprets all treatments delivered within three hours of
the first treatment in any given session as part of the same
session. Also, if a portal image has no associated treatment field,
MOSAIQ makes a chart entry, but the session number is not
incremented.
Select so radiation treatment plans must be approved before
MOSAIQ permits treatment.
Select so radiation treatment calibration must be approved before
MOSAIQ permits treatment This is specific to Particle Delivery
Select to activate an alert that appears before MOSAIQ opens a
treatment field or delivers a treatment if the portal image was not
reviewed or if a physician rejected the portal image. This only applies
if your department has Image Management registered.
Select to show dose check warnings. These warnings appear
whenever you select a field for treatment that will not contribute dose
to the prescription site or it is not associated with a prescription site.
The warning messages are as follows:
Treatment field dose is zero. Do you want to treat the field
with no dose defined?
Treatment field is not associated with prescription site.
Continue?
A dose site coefficient has either not been defined or set up
so that the treatment of this field will not contribute any
dose to the prescription site. Continue?
Refer to Pre-Treatment Warnings in Appendix B on page 282.
254 Copyright 2010, Elekta Impac Software
LUGMSQ0002/4.0/23-Sep-2010