MOSAIQ User's Guide - UCSF Radiation Oncology

Viewing and Enhancing Images
CHAPTER 7: Image Management-ViewStation & Photos and Diagrams
The Image window provides tools for enhancing and changing the view of images.
CAUTION
Magnifying Images
To apply basic image viewing options, you must have Image |
ViewStation | Basics | Enable security rights.
To view and change images, you must have Image | ViewStation |
Images | View and Modify security rights and Image | ViewStation |
Image Information | View and Modify security rights.
To save and print images, you must have Administrative | General |
Modify security rights.
To copy and remove images, you must have Image | ViewStation and
Maintenance | Copy/Move Images | Enable and Delete Images | Enable
security rights.
1. Open the patient’s chart.
2. Click eChart | Images… to open the Image List window.
3. Double-click the image, or click the image, then click Open to open the image in the
Image window.
4. In the toolbox, click to zoom in on the image.
Notice the zoom tools and zoom factor at the top of the Image window.
You cannot change the zoom factor field.
5. Click twice to zoom out on the image.
100% identifies a 1:1 mapping of image pixels to monitor pixels.
When the zoom ratio is reduced below 100%, a single monitor pixel
shows multiple image pixels that have been combined by
resampling.
6. If you wish to magnify a specific area of the image, click and drag the scroll bar at the
bottom of the image viewer to show the area you wish to magnify, then click and drag
the scroll bar on the side of the image viewer to best position the area you wish to
magnify.
7. In the toolbox, click twice.
8. Click Cancel, then double-click the same image if you wish to reset the image
magnification to the original settings and cannot remember the original zoom factor.
Copyright 2010, Elekta Impac Software 169
LUGMSQ0002/4.0/23-Sep-2010