MOSAIQ User's Guide - UCSF Radiation Oncology

MOSAIQ User’s Guide
Clearing Reticle Scaling
1. In the Image List window, click the image for which you wish to clear reticle scaling,
then click Open.
2. Right-click or press F4, then click Clear Reticle Scaling.
You cannot clear reticle scaling of an image already used in a
treatment field that was treated. The Image window shows Historic
for these images.
3. Click OK to close the Image window.
Reticle Scaling Verification Images
Reticle scaling verification images is the process of defining the isocenter and magnification
(scaling) factors of verification images. This section provides instructions for reticle scaling
verification images with and without graticules.
Reticle Scaling Verification Images with Graticules
You can only use the instructions in this section to reticle scale verification images that
already had a graticule on them before being imported into MOSAIQ. This “burned-in”
graticule on the image represents the central axis and relative scale of the image.
1. Click Tools | Image Work List to open the Image Work List dialog box.
To generate a specific list of images, refer to Checking the Image
Work List for Images Requiring Reviews in this chapter on page 182
or Checking Changes Required from the Image Work List on page
187.
2. In the Image Work List dialog box, click the patient name listed in the table to the right
of the Criteria group.
This shows the images for the selected patient in the image information table at the
bottom of the dialog box.
3. In the lower section of the Image Work List dialog box, click the image you wish to
review, then click Review to open the image(s) in the Image Review window.
You can also open the image pair in the Image Review window from
the Image List window, refer to Reviewing/Approving Images from
the Image Work List on page 184.
4. Click the Isocenter Offset tab, then click Register to open the images in the Image
Registration window.
5. Click the verification image to make it active.
156 Copyright 2010, Elekta Impac Software
LUGMSQ0002/4.0/23-Sep-2010