1975 Datsun 280z FSM - Spooled up Racing

Use the same procedure as in step
9A, and check continuity between
terminal @ and body metal.
Refer to Figure EF-48 for circuit
details.
2. Continuity check using a
voltmeter (1)
Engine Fuel
Notes:
a. Set circuit tester in the DC VOLT
(DC "V") range.
b. Connect negative terminal of voltmeter
to body metal with a lead
wire.
c. If tests check out "N.G.", be sure
to turn off the ignition switch and
to disconnect battery ground cable
before tracing the circuit.
as follows:
• Turn ignition switch to the "OFF"
position.
• Check the circuit indicated by large
solid and dotted lines in Figure
EF-51.
3B) Terminal © (Cylinder "1")
Use the same procedure as in step
3A, and take voltmeter reading between
terminal © and ground.
Refer to Figure EF-52 for circuit
details.
3C) Terminal