1975 Datsun 280z FSM - Spooled up Racing

Body Electrical System
LAMP BODY REPLACEMENT
1. Remove two screws .retaining
lamp body to rear finisher and take
out lamp body.
2. Disconnect pair of lead wires at
connectors.
3. Install new lamp body in the
reverse sequence of removal.
MAP LAMP
BULB REPLACEMENT
1. Remove four screws retaining
instrument finisher to instrument
panel.
2. Pulling instrument finisher out a
little, disconnect lead wires at three
connectors. Instrument finisher can
then be removed from instrument
panel.
Note: Three connectors are for map
lamp, floor temperature warning
lamp (California models) and catalyzer
warning lamp (California
models).
3. Twist socket behind map lamp
and remove socket with bulb.
4. Extract bulb from socket.
5. Installation is in the reverse sequence
of removal.
Bulb wattage:
Map lamp
5W
Fig. BE-34
1 Socket
2 Bulb
3 Lamp body
BE990
License lamp
3. Remove two screws retaining map
lamp body to instrument finisher.
Lamp body can then be taken out.
4. Installation is in the reverse sequence
of removal. 1 Catalyzer warning lamp
BE 617A
2 Map lamp
3 Floor temperature warning lamp
Fig. BE-35 Removing instrument
finisher
LAMP BODY REPLACEMENT
1. Remove four screws retaining
instrument finisher to instrument
panel.
2. Pulling instrument finisher out a
little, disconnect three connectors. Instrument
finisher can then be removed
from instrument panel.
Note: Three connectors are for map
lamp and for floor temperature
warning lamp (California models)
and catalyzer warning lamp
(California models).
Floor temperature warning
lamp (California models)
Map lamp
Catalyzer warning lamp
(California models)
Fig. BE-36
BE618A
Map lamp
BE-25