21.07.2014 Views

1975 Datsun 280z FSM - Spooled up Racing

1975 Datsun 280z FSM - Spooled up Racing

1975 Datsun 280z FSM - Spooled up Racing

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

CIGARETTE LIGHTER<br />

DESCRIPTION<br />

The cigarette lighter consists of<br />

lighter, housing, housing cover, and<br />

illumination lamp.<br />

The housing is secured on instrument<br />

panel 'by housing cover. A fuse is<br />

added at the bottom of housing. When<br />

pushed into housing, lighter is retained<br />

by nails in housing and gets continuity<br />

through heater coil at end of lighter.<br />

When heater is warmed enough, the<br />

bi-metal nail frees lighter. Lighter then<br />

pops out by spring back, and breaks its<br />

continuity.<br />

Body Electrical System<br />

4. Remove retaining nut at bottom<br />

of cigarette lighter.<br />

Housing and housing cover can then<br />

be taken out from instrument panel.<br />

5. Installation is in the reverse sequence<br />

of removal.<br />

Illumination lamp<br />

1. Remove tachometer referring to<br />

page BE-38 for Removal.<br />

2. Disconnect lead wires for illumination<br />

lamp at a connector.<br />

3. Remove illumination lamp retaining<br />

screw and take out lamp assembly<br />

through the hole in which tachometer<br />

is installed.<br />

INSPECTION<br />

Test continuity of whole system<br />

with test lamp or ohmmeter, referring<br />

to cigarette lighter circuit diagram.<br />

ILLUMINATION BULB<br />

REPLACEMENT<br />

1. Remove tachometer referring to<br />

page BE-38 for Removal.<br />

2. Pull out socket with bulb from<br />

housing. Refer to Figure BE-118.<br />

3. Remove bulb from socket.<br />

4. Install new bulb and assemble in<br />

the reverse sequence of removal.<br />

Bulb wattage:<br />

Cigarette lighter illumination<br />

bulb 3.4W<br />

Fiber scope for cigarette lighter illuminator<br />

1<br />

2<br />

3<br />

4<br />

5<br />

Lighter<br />

Escutcheon<br />

Housing<br />

Fuse<br />

Spacer<br />

6 Cover<br />

7 Fiber scope for<br />

illumination<br />

8 Retaining nut<br />

BE149A<br />

Fig. BE-117 Cigarette lighter<br />

REMOVAL AND<br />

INSTALLATION<br />

Cigarette lighter<br />

1. Remove battery ground cable.<br />

2. Remove lighter from housing.<br />

3. Disconnect two lead wires for<br />

cigarette lighter at connectors and the<br />

fiber scope at illumination lamp housing<br />

by twisting fiber scope.<br />

Note: It is recommended that tachometer<br />

be removed prior to this<br />

step.<br />

It is easy to remove and install<br />

cigarette lighter and illumination<br />

lamp through the hole in which<br />

tachometer is installed.<br />

BE150A<br />

Fig. BE-118 Illumination lamp<br />

BE-69

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!