1975 Datsun 280z FSM - Spooled up Racing

REMOVAL
1. Disconnect battery ground cable.
Disconnect black wire with yellow
stripe from magnetic switch terminal,
and black battery cable from battery
terminal of magnetic switch.
2. Remove two bolts securing starting
motor to transmission case. Pull
starter assembly forward and remove
starting motor.
DISASSEMBLY
TYPE S114-122N
Engine Electrical System
EE013
Fig. EE-11 Setting free brushes
6. Remove pinion stopper located at
the end of armature shaft. To remove
stopper, first remove stopper washer
and push stopper to clutch side and
then, after removing stopper clip, remove
stopper with over-running
clutch. Withdraw over-running clutch
assembly from armature shaft.
1. Loosen nut securing connecting
plate to magnetic switch "M" terminal.
Remove three screws securing
magnetic switch and remove magnetic
switch assembly.
EE014
Fig. EE-12 Removing brush holder
Fig. EE-15
EE012
Removing over-running
clutch assembly
4. Remove yoke assembly by hitting
lightly with a wooden hammer.
TYPE SI 14-182
Fig.
EE008
EE-9 Removing magnetic switch
assembly
2. Remove two through bolts and
rear cover.
Fig. EE-13
EE010
Removing yoke assembly
1. Disconnect connecting plate from
"M" terminal of magnetic switch. Remove
two screws securing magnetic
switch and remove magnetic switch
assembly.
2. Remove dust cover, E-ring and
thrust washer(s).
5. Withdraw armature assembly and
shift lever.
EE317
EE009
Fig. EE-10 Removing brush cover
Fig. EE-16 Removing dust cover,
E-ring and thrust washer(s)
3. Set brushes free from commutator
by lifting up brush springs.
EE011
Fig. EE-14 Removing armature
assembly and shift lever
EE-8
3. Remove two screws securing
brush holder assembly.