1975 Datsun 280z FSM - Spooled up Racing

GLOVE BOX LAMP
BULB REPLACEMENT
Bulb is installed at the bottom of
lamp body. Pushing the bulb into
switch body, twist it counterclockwise.
Bulb can then be taken out.
Install new bulb in reverse sequence of
removal.
Bulb wattage:
Glove box lamp 3.4W
LAMP BODY REPLACEMENT
1. Disconnect battery ground cable.
2. Disconnect pair of lead wires at
connectors in glove box.
3. Pull the lamp body with bulb out
from bracket.
4. Installation is in the reverse sequence
of removal.
Body Electrical System
AUTOMATIC ]
TRANSMISSION
INDICATOR LAMP
The indicator lamp is located in the
indicator finisher and illuminates the
indicator of select lever. Removal and
installation is described in Section BF.
BULB REPLACEMENT
1. Remove console box.
2. Remove torque converter indicabulb
tor finisher.
3. from
Remove socket with
beneath indicator finisher
4. Remove bulb from socket cet.
5. Install new bulb in the reverse
sequence of removal.
Bulb wattage:
Automatic indicator
lamp
. . . . 3.4W
Con rol lever
INSPECTION LAMP
Inspection lamp is located on left
side of engine room. Should some
mechanical difficulty occur at night,
this lamp is extremely useful for detection
of the source of the problem
and/or illumination of the repair job.
REMOVAL AND
INSTALLATION
1. Disconnect lead wire at a connector.
2. Remove two screws retaining
lamp to engine room. Lamp assembly
can then be taken out easily.
3. Installation is in the reverse sequence
of removal.
INSPECTION
Test continuity between two lead
wires. When plunger is pressed into
lamp body, continuity must not exist.
Conversely, continuity must exist
when the plunger is projecting.
ition lamp
BE993
Fig. BE-39 Inspection lamp
Fig. BE-38
Automatic
BE513
transmission
indicator lamp
BULB REPLACEMENT
1. Twist socket and lens and take
out them from lamp housing.
2. Push on lens and twist counterclockwise.
Lens can then be taken out
from socket.
3. Push in on bulb and twist bulb
counterclockwise. Bulb can then be
taken out from socket.
BE992
Fig. BE-37 Glove box lamp
INDICATOR LAMPS
Turn signal pilot lamps and main
beam indicator lamp are installed on
tachometer and speedometer.
They can be replaced easily by
pulling socket, with bulb, from back
of meter. Refer to following section
"Meters and Gauges".
BE-26
INSPECTION
Test continuity between terminal
for power source harness and body at
each step of switch. Test can be
carried out by using ohmmeter or test
lamp.