1975 Datsun 280z FSM - Spooled up Racing

INTERIOR LAMP
BULB REPLACEMENT
1. Remove interior lamp assembly
from roof. Interior lamp is retained by
its spring back.
2. Pulling lamp body out a little,
disconnect three connectors on its
back.
3. Remove bulb from lamp body
through the hole in its back.
4. Install new bulb in the reverse
sequence of removal.
Bulb wattage:
Room lamp
1OW
LAMP BODY REPLACEMENT
1. Remove lamp body from roof.
• Lamp body is attached by its spring
back.
2. Pulling body out from roof, disconnect
three connectors. Lamp body
can then be taken out easily.
3. Install new lamp body in the
reverse sequence of removal.
Body Electrical System
REAR COMBINATION
LAMP
BULB REPLACEMENT
1. Remove four screws retaining
trim cover lid from inside of trunk.
2. Through the hole in the rear
panel trim lid,, twist socket counterclockwise
and . remove socket with
bulb.
3. Press in on bulb, twist it counterclockwise,
and remove it from socket.
4. Install new bulb in the reverse
sequence of removal.
Bulb wattage:
St °P/ Tail
Tail
Turn
Reverse
23W/8W
8W
23W
23W
BE988
Fig. BE-32 Replacing bulbs
LAMP BODY REPLACEMENT
1. Remove plastic rivets retaining
rear panel finisher and make rear panel
finisher free. Refer to Section BF for
details.
2. Remove screws retaining rear trim
cover and take out rear trim cover.
3. Disconnect lead wires for rear
combination lamp at a connector.
4. Remove six flange nuts retaining
rear combination lamp body to rear
body panel. Lamp body can then be
taken out.
5. Rear panel finisher can be separated
by removing four screws.
6. Installation is in the reverse sequence
of removal.
LICENSE LAMP
BULB REPLACEMENT
1. Remove two screws retaining
lamp body to rear panel and take out
lamp body. Refer to Figure BE-34.
2. Twist the socket counterclockwise
and remove socket, with bulb,
from lamp body.
3. Push in on bulb and twist it
counterclockwise. Bulb can then be
easily taken out from socket.
4. Install new bulb in the reverse
sequence of removal.
Bulb wattage:
License lamp 7.5W x 2
-\£S\
Pls^