1975 Datsun 280z FSM - Spooled up Racing

Body Electrical System
HEADLAMP
AIMING ADJUSTMENT
Both vertical and horizontal aiming
adjustment can be carried out through
the cutting hole of headlight case.
Adjust the adjusting screw on upper
side of each headlamp to adjust
vertical aiming and adjust the adjusting
screw on side of each headlamp to
adjust horizontal aiming as sketched
below.
Notes:
Before making headlamp aiming
adjustment, observe the following:
a. Keep all tires inflated to correct
pressure.
b. Place car and tester on the same flat
surface.
c. See that there is no load in car.
1) Gasoline, radiator and engine oil
pan filled to correct levels.
2) No passenger.
When performing headlamp aiming
adjustment, use an aiming device,
aiming wall screen or headlamp tester.
For operating instructions of any
aimer, refer to the operation manuals
supplied with the unit.
Adjust each headlamp beam as
shown in Figure BE-27.
v/; r 77-y •V////\v///// .