1975 Datsun 280z FSM - Spooled up Racing

I
Body Electrical System
ADJUSTMENT
Wiper motor and linkage
Wiping area
15 (0.591) 35(1.378)
=4=
[Min. 15
(0.591),
Max. 48
5,(1.890)]
1. Remove wiper arm referring to
previous section.
2. Open hood, and disconnect wiper
motor connector.
Windshield wiper blade
BE626A
Windshield wiper arm
Windshield wiper motor
Assistant side
Unit: mm (in)
Driver side
Fig. BE-106
BE142A
Wiping area
Fig. BE-109 Connector for wiper
motor
3. Remove cowl top grille by
removing cowl top retaining screws.
To adjust wiping area, loosen arm
set nut and adjust blade to correct
installation angle to obtain correct
sweeping zone as sketched in figure
above.
Then, secure nut at specified tightening
torque.
Tightening torque:
Wiper blade arm lock nut:
0.8 to l.Okg-m
(5.8 to 7.2 ft-lb)
Nozzle direction
Adjust nozzle direction so that
fluid is sprayed in proper range by
bending nozzle with screwdriver. This
adjustment can be carried out through
cowl top grille.
Car body center
* Adjusting range 100 (3.9) dia.
REMOVAL AND
INSTALLATION
Wiper arm and wiper blade
Remove arm and blade assembly
from pivot in this sequence.
1. Raise wiper blade from windshield
glass.
2. Unscrew arm set nut. Arm can
then be pulled off pivot.
3. Install in reverse sequence of
removal.
Note: Be sure to install arm and blade
assembly in correct peak position.
Position of blade can be adjusted
when pushing it onto pivot.
Tightening torque:
Arm set nut:
0.8 to l.Okg-m
(5.8 to 7.2 ft-lb)
To remove blade, raise tab to unlatch
blade lock and pull blade off top
end of arm.
BE144A
Fig.BE-110 Wiper motor
4. Remove four screws retaining
wiper motor bracket.
The bracket with wiper motor can
then be taken out. Refer to Figure
BE-110.
5. Remove three screws retaining
pivot.
6. The linkage can then be taken out
easily. Refer to Figure BE-111.
•®-:-&'
Unit: mm (in)
Nozzle BE573A
Fig. BE-107 Nozzle direction
—