1975 Datsun 280z FSM - Spooled up Racing

COMBINATION
SWITCH
The combination switch consists of
light switch, wiper -switch, washer
switch, turn signal and dimmer switch.
The two levers on the switch are for
turn signal switch and for light and
wiper switch. They can be separated
into two pieces. Position the turn
signal switch lever at the first stop
position, left or right direction, when
changing lanes. Turn signal lamps operate
until the lever is released. Move the
lever up and down to change headlamp
between high and low beam.
Lighting switch is operated by a
dial and a small knob. Wiper switch is
operated by outer dial; washer switch
is at the top of the switch lever.
Body Electrical System
3. Disconnect lead wires from combination
switch at six connectors.
They consist of one large connector
with nine terminals; two with three
terminals and three with one terminal.
4. Remove two screws retaining
combination switch to steering column
jacket.
The switch will then separate into
two pieces and can be easily removed.
Note: There is a lead wire between
L.H. and R.H. piece. It is unnecessary
to disconnect the connector
for it.
5. Installation is in the reverse sequence
of removal.
Note: Make sure that location tab of
combination switch lines up with
hole in steering column jacket.
Location tab is inside of turn signal
switch.
INSPECTION
Test continuity through turn signal
switch at each step and position with a
test lamp or ohmmeter. Consult continuity
diagram described in Figure
BE-41.
REMOVAL AND
INSTALLATION
1. Disconnect battery ground cable.
2. Remove all screws retaining shell
covers to each other and remove shell
covers from steering column jacket.
BE994
Fig. BE-40 Removing combination
switch
\
4
5
6
7
L
H
E
2
3
W
B
1
LIGHT
OFF 1
0
6
2
9
6
9
6
WIPER
OFF 1
L
9
9
6
c !> 6
_0
O
T
6
o
H
O
p
0
WASH
OFF ON
9
o
p
o
10
11
14
15
16
18
TURNSIGNAL DIMMER HOW
R M D
L N
0
It ^
9
6
9
T 6
9
6
o
• tr
© ® (D
BE995
Fig. BE-41 Combination switch
BE-27