21.07.2014 Views

1975 Datsun 280z FSM - Spooled up Racing

1975 Datsun 280z FSM - Spooled up Racing

1975 Datsun 280z FSM - Spooled up Racing

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Body Electrical System<br />

ELECTRIC REAR<br />

WINDOW DEFOGGER<br />

DESCRIPTION<br />

The electric rear window defogger<br />

system consists of defogger switch,<br />

defogger relay, defogger warning lamp<br />

and filament in the rear window glass.<br />

The filament is attached inside rear<br />

window. Heat from filament keeps<br />

rear window free of fog and frost.<br />

Defogger relay is located on relay<br />

bracket.<br />

Defogger switch and relay is installed<br />

on console box.<br />

Defogger warning lamp<br />

1 Lamp body<br />

2 Bulb<br />

3 Socket<br />

BE672A<br />

Fig. BE-123 Defogger switch and warning lamp<br />

REMOVAL AND<br />

INSTALLATION<br />

Defogger switch,<br />

warning lamp<br />

Defogger switch is held against<br />

console box by spring pressure.<br />

1. Disconnect battery ground cable.<br />

2. Remove console box referring to<br />

Section BF.<br />

3. From behind console box, grasp<br />

nail of switch body and push it out of<br />

console box.<br />

4. Disconnect lead wires at a connector.<br />

5. Installation is in the reverse sequence<br />

of removal.<br />

Note: In installing, switch body can<br />

be installed on console box only by<br />

pressing it in.<br />

1 Engine room harness<br />

2 Dash harness<br />

3 Instrument harness<br />

4 Fuse block<br />

5 Catalyzer hold relay<br />

Air-con relay<br />

Defogger relay<br />

Horn relay<br />

Intermitter wiper<br />

relay<br />

BE592A<br />

Fig. BE-124 Defogger relay<br />

Defogger relay<br />

Defogger relay is located on relay<br />

bracket.<br />

1. Remove battery ground cable.<br />

2. Disconnect lead wires for defogger<br />

relay at a connector.<br />

3. Remove two screws retaining<br />

relay to relay bracket.<br />

Relay can then be taken out easily.<br />

4. Installation is in the reverse sequence<br />

of removal.<br />

WARNING LAMP BULB<br />

REPLACEMENT<br />

1. Remove console box referring to<br />

Section BF.<br />

2. Push socket with bulb behind<br />

warning lamp body and twist it counterclockwise.<br />

Socket with buib can then be taken<br />

out.<br />

3. Remove bulb from socket.<br />

4. Install new bulb. Assembly is in<br />

the reverse sequence of removal.<br />

BE-72<br />

Bulb wattage:<br />

Rear window defogger warning<br />

lamp 1.4W<br />

INSPECTION<br />

Defogger switch<br />

Test continuity of switch by using<br />

test lamp or ohmmeter. Test must be<br />

carried out with switch at both ON<br />

and OFF. Refer to Figure BE-123<br />

continuity diagram of defogger switch.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!