1975 Datsun 280z FSM - Spooled up Racing

Washer nozzle
1. Remove washer nozzle fixing
screws from cowl top panel.
2. Take out washer nozzle with
tube.
3. Install in reverse sequence of removal.
1 Nozzle
2 Windshield washer motor
3 Windshield washer tank
BE200A
Body Electrical System
Never mix soap powder or detergent
with solution.
2. Do not operate windshield washer
continuously for more than 30
seconds or without washer fluid. This
often causes improper windshield
washer operation. Normally, windshield
washer should be operated 10
seconds or less at one time.
Wiper switch
Wiper switch and washer switch are
integral parts of combination switch,
so, refer to page BE-27 for Removal of
Combination Switch.
Intermitter wiper relay
The intermittent wiper relay is installed
on relay bracket.
1. Disconnect two connectors for
intermittent wiper relay.
2. Remove intermittent wiper relay
retaining screws.
Then, intermittent wiper relay can
be taken out of bracket.
3. Installation is in the reverse sequence
of removal.
Fig.BE-112 Washer nozzle
Washer pump and tank
The washer pump is installed at
bottom of washer tank.
1. Remove washer tank with washer
motor from tank bracket in engine
room.
2. Disconnect two washer pump
lead wires at connectors.
3. Remove hoses from washer pump
and drain washer fluid.
4. Separate washer pump from
washer tank.
5. Install washer tank and motor
assembly in reverse sequence of removal.
Note: In assembling washer motor
and washer tank, it is recommended
that soapy water be used to facilitate
the operation.
BE556
1 Washer tank
2 Washer pump
Fig. BE-113 Washer pump and tank
INSPECTION
Check operation of each part of
wiper system and test continuity of
system with ohmmeter or test lamp.
For electrical wiring, refer to
Figures BE-115 and BE-116 windshield
wiper circuit diagram.
Caution for windshield
washer operation
1. Be sure to use only washing
solution.
BE-62
BE592A
1 Engine room harness
2 Dash harness
Instrument harness
Fuse block
Catalyzer hold relay
Air-con relay
Defogger relay
Horn relay
Intermitter wiper
relay
BE146A
Fig. BE-114 Intermitter wiper relay